Home > Parts for Defender​® > Body Panels and Body Parts > Doors & Ancillaries > Rear Doors & Pick Up Tailgates with Ancillaries > Fully Assembled Rear Doors & Rear Door Kits >

JWP5084 - Fully Built Up Galvanised Rear Door Un-Glazed To Spec (Galv Steel Skin) 83-02 (2-4 Week Lead Time)

JWP5084 - Fully Built Up Galvanised Rear Door Un-Glazed To Spec (Galv Steel Skin) 83-02 (2-4 Week Lead Time)
 
Our Price: £299.95 (359.94 inc VAT If in UK)



Product Code: JWP5084


Colour Of Rear Door Card*: 		Black (TR240)
Dark Grey (TR241)
Light Grey (TR242)

Rear Door Hinge & Bolt Kit Unfitted*: 		With Rear Door Hinge & SS Bolt Kit (SP901 & BK0188) [Add £40.00]
Without

With door loom?*: 		No loom
With loom [Add £40.00]

With Grab Handle (MUC1402)*: 		With Grab Handle [Add £30.00]
Without Grab Handle

With Rear Wiper Motor?*: 		With Wiper Motor (Inc Arm & Blade) [Add £40.00]
Without Rear Wiper Motor (No Wiper Hole In Door)

With Wheel Carrier?*: 		With Wheel Carrier [Add £40.00]
Without Wheel Carrier

Qty:  
Description
 

Fully Built Up Galvanised Rear Door Un-Glazed - Built To Your Specification (Galv Steel Skin) 83-02
To Fit All Models Between 1983-2002

This comes all ready to fit to your Defender, built to your specification
Choose From:
Door Card Colour
Grab Handle Fitment
Wheel Carrier Fitted
Door Hinges & Stainless Bolt Kit

This is a high quality UK made door with exact pressings as per original

The frame is hot dipped galvanised and the zinc plated steel skin is marine bonded to the frame to prevent corrosion through the two surfaces rubbing together. This also stops the drumming effect & makes the door feel a lot stronger & tighter all around.
The galv steel skin is 1mm thick and adds a lot of extra strength to the overall door

This is made in the UK to precise and exact tolerances, you will not find better quality on the market!

This is a direct swap for your old rusty door with no modifications needed.



Important note, you must not sand off any of the zinc coating on the skin before painting as this will remove the zinc coating and remove it corrosion resistance.
The zinc coating on the skin is perfectly smooth as it is applied electronically. Whoever paints the panel must be given the instructions to simply go over the skin and frame with Mordant solution / T wash which etches the zinc finish black and means the paint will properly adhere. You should then go over with an etch primer, then a high build primer and then finally your colour coats. Do not sand the skin at all before any paint is applied.

A £50 fixed shipping cost is on this item for the wooden crate.